If somehow the bottle of your foam pump becomes clogged, the problem may be caused by minute particles trapped on the fine mesh screen that is included inside the foam pressure head. Or, if you have yet to use the pump very often, the liquid soap could have a chance to gradually turn into a gel and develop a deposit on the mesh screen, which would also cause the blockage. While using soap nut liquid with a foam pump container, you may discover that the bottle has the propensity to get clogged up rather quickly. This is because soap nut liquid has a high concentration of glycerin. It is most likely caused by the minute remnants of soap almond liquid that remain in the liquid and become trapped at the membrane filter. Because of this, it is essential to filter the liquid made from soap nuts as thoroughly as possible. To assist me with that, I use thick coffee filter paper.
Second, unlike liquid soap, washing powder nut liquid does not have a silky texture due to its origin. On the contrary, it creates more “friction” in the water. Because of this, friction will build up within the pressure head throughout time, and the head will not spring back into place as smoothly as it normally would. My observations led me to this conclusion. If you like using soap nut foam quite a bit, you may find that the bottle of foam you use has to be unclogged more often than usual. To alleviate this problem, one solution that has been suggested is to mix one or three tablespoons of additional liquid soap, which includes Dr. Bronner’s washing-up liquid, with the washing powder nut liquid. This will assist in lubricating the spring somewhere at the neck to function more effectively.
Unclogging The Bottle Of Your Foam Pump May Be Done As Follows:
- Turn off the screw and then take off the pump head.
- Pull firmly to remove the cap from the nozzle.
- Water should be used to rinse the mesh screen.
- The other portion has to be rinsed.
- Flip the device over and then push upward on the pump to drain the water from the air chamber.
- Replace the nozzle cap in its original location.
- Continue applying firm pressure until you hear a click.
During using soap nut solution with something like a foam pump bottle, visitors may discover that the bottle has the propensity to get clogged up rather quickly. This is most likely caused by the minute remnants of soap nut solutions that remain in the liquid and become trapped somewhere on the mesh screen. Because of this, it is essential to filter the liquid made from soap nuts as thoroughly as possible. To assist me with that, I use a small coffee filter paper.
Second, unlike liquid soap, washing powder nut liquid does not have a silky texture due to its origin. On the contrary, it creates more “friction” in the water. Throughout time, this would result in friction inside the pump head, and the head would not spring back into place as smoothly as it normally would. My observations led me to this conclusion. If you like using soap nut foam quite a bit, you may find that the bottle of foam you use has to be unclogged more often than usual. Adding one or more tablespoons of liquid soap to the soap nut liquid to lubricate the shock absorber at the neck and make it function more effectively is one potential recommendation that may be made to assist with this problem.